Power Punch Upgrade Kit Instructions

1.  Install the spacer between the Power Punch Table and the Arm Bracket.

1. Remove the handle by removing the two 5/8" screws located on back of the table assembly.  (Remove by turning counter-clockwise with a screwdriver).

2. Install the spacer between the table assembly and the handle, then use the two 1.5" screws provided to re-attach the handle.  (Go to step 3 if you have the Professional Model).

2.  Handle Adjustment (PP200 Only)

1. Loosen the handle screws so the spacer can move.

2. Install a template on the table, and gently push the spacer against the template.  Make sure the template is centered on the table and that you can wiggle the end slightly.  Carefully tighten the screws.

3. Verify the fit of all the templates.  If any are too tight, simply loosen the screws again and repeat steps a) and b).

3.  Attach the Plunger Adapter to the Power Punch Plunger using the Velcro included in the kit.  Use the plunger adapter when using small punches.  Remove when using the super giant or silhouette punch types.

4.  Install the no-slip protective vinyl surface by centering it on the table and pressing out the air bubbles.  The protective vinyl helps to hold your punch in place.

Power Punch Instructions

Power Punch Tips

Handy Helper Template Instructions